An information, is given about the method of strengthening the tested samples by the general requirements of plant’s manufacturer for three types of composite materials. It was presented a dates about the application stages and control of the load intensity  

Keywords: Concrete, cement grout, notching, primer, putty, glue composition, stages of loading, the load level indicator, graduation

Provides information about the strength of the concrete, the size of the cross section of experienced beams, the options of their reinforcing and strengthening with various types of composite materials. Provides a scheme of testing with short-term load  

Keywords: Steel, concrete, reinforced concrete, strengthening, anchors, span , percentage of steel and composite reinforcement, load, failure

The paper shows the feasibility of using a current amplifier in the filters RF and microwave ranges. By analyzing the basic structure of the second-order level sufficient conditions for the efficient use of active elements. The examples of methodological nature and formulated conclusions of practical importance.

Keywords: RF filter, microwave filter, parametric sensitivity, current amplifiers, functional modeline setting

In this paper a form of expression in the matrix to determine the unknown ratios in double rows, appoksimiruyuschih displacement of a point of the middle surface of the shell, which is used in calculating the shell variation-energy method  

Keywords: envelope variation-energy method, the minimum total potential energy of the system, movement, deformation.

  This paper presents a method of constructing microwave selective amplifiers, which allows control Q and voltage gain at the frequency of quasi-resonance. The presented architecture selective amplifiers for SiGe process technology have low power consumption.

Keywords: RC-filter, good quality, controlled selective amplifier, gain, frequency quasi-resonance

The results of operation of electric locomotives «O'ZBEKISTON». Describes the general characteristics of the railways in Uzbekistan, the basic characteristics of electric series «O'ZBEKISTON». It also presents calculations of generalized reliability indicators and the main directions of development of repair systems.

Keywords: Railways of Uzbekistan, electric locomotives series «UZBEKISTAN», reliability

This paper describes application of different criteria for estimating parameters of traffic simulation. For comparison following methods were used: statistical methods for comparison of a flow and speed in control points of a network - analysis of variance (ANOVA), Theil's U-statistics; relationships between flow, density and speed; relationships between trip time and stop time with using two-fluid models of traffic flow. For this aim we also used concept of meta-model. In order to implement this method we need on the first step to create separately relationship between traffic flow parameters for observation and simulation data and then to estimate combined model. The paper included results of calculation  

Keywords: validation, traffic, simulation, flow, speed

"The concept of the nested metagraph as the model of a complex object with different levels of generalization is introduced. It is shown that the nested metagraphs reflect the general system concept for description of complex objects with synergistic effect. This approach enables moving from the set-theoretic description of complex objects to their algebraic-theoretic description, thus increasing the model adequacy to real-life objects. The application of the nested metagraphs, in particular to business-intelligence and semantic search is considered. "

Keywords: nested metagraphs, complex object, hyperedge as the essence, business analysis, a semantic network

The main models of DNA computing are self-assembly of DNA and RDNA. Disadvantages of these models are low speed perform arithmetic operations, the high probability of errors of computing, and perform the calculation with only fixed-point numbers. In article is represented method of encoding numbers by DNA strands. Numbers can be encoded by any base initially. This method does not require to translate the number into a binary number system. Each number is encoded by digit with the DNA. As compared with known methods, the proposed method uses a shorter length of DNA strands. The proposed method can increase speed encoding of numbers, improve the accuracy of the calculations and to reduce errors in the formation of the encoded data. In article is represented also the operations to perform arithmetic operations. The use of the proposed method of encoding numbers and proposed operations over DNA allows to increase speed of computation, and perform calculations not only with fixed-point numbers and floating-point numbers.

Keywords: encoding of numbers, DNA strands, operations with the DNA-chain, DNA computing

The spectra of thermally stimulated conduction currents (TSCC) in (TmBi)3(FeGa)5O12:Ca2+ ferrite-garnet films have been investigated with the purpose to reveal electrically active centres. The samples were fabricated by liquid phase epitaxy (LPE) from melt solution on the Gd3Ga5O12substrates with the crystallographic orientation (111) with the use of Bi-containing flux (without Pb). Increasing the concentration of Ca2+ions in the films were realised by increasing the concentration of CaO in the melt solution. The obtained films contained Ca2+ ions from 0,03 f.u to 0,1 f.u. With the help of standard thermoactivation current spectroscopy the spectra of the initial samples and samples subjected to ultraviolet radiation and negative corona discharge were obtained. The characteristic parameters of electrically active defects were calculated.

Keywords: thermally induced electrical current, ferrite garnet films, electrically active centres, deep-level capture, charge compensation, Ca- doping, ТСТП-spectra, temperature position

  The model of on-line transaction processing system architecture constructed by a principle of cloud structure is considered. The mathematical model of OLTP-system as the queuing system is offered. Results of modeling and their analysis are led.

Keywords: On-line transaction processing system, Cloud architecture, Distributed database, Queuing system

Most of web pages of the Web are inaccessible for the blind users. And the main reason is a lack of the semantics at the source code (technical) level of web pages and absence of the navigational components. In this work we propose a new web page representation---multiaxial navigation model---representing web documents in the form convinient for the blind users. Moreover, we present methodology for the navigation on the model proposed, that ensure an efficiency of user mobility. Automatic transformation of a web page into the multiaxial navigation model and navigation means are realized in the Blindzilla prototype. An efficiency of the proposed concepts is proven experimentally regarding contemporary screen readers, such as JAWS, Window-Eyes, and Fire Vox.

Keywords: web accessibility, navigation, web page, web technologies

  The article is devoted to the problem of the research of geopolitical processes on the world regions’ scale under present-day conditions. The article substantiates the necessity of their analysis with the help of the cognitive approach as an effective means of cognition of the interconnections and interrelationships within the complicated systems. With that aim in view the specifics and the stages of the cognitive modeling are given thorough analysis in the article. This type of modeling is adapted to the analysis of geopolitical dynamics on the regional/sub regional level taking into consideration its aptitudes to make prognostic scenarios of the development of the situation. The possibilities of the cognitive modeling of geopolitical processes are illustrated on the example of the situation in three sub regions constituting one (big) the Black Sea – Caspian region.

Keywords: World regions, geopolitical processes, modeling of the complicated systems, modeling of the geopolitical processes, cognitive modeling, the program’s system of the cognitive modeling, the Black Sea – Caspian Region, the Black Sea sub region, the Caucasus

Decision making in the organizational and technical systems is complicated by the risk of various events emergence in the systems with a given probability. The article describes a method for supporting decision making under risk on the basis of integration of evolutionary, multi-agent, simulation models and numerical methods. In the course of the method's work the following steps are performing: a set of alternatives solutions is formed;  transition to a one-criterion alternatives evaluation is fulfilled by using linear convolution; transition to the system behavior certainty is fulfilled with the use of numerical optimization Bayes-Laplace criterion. The developed method is applied to solving the projects scheduling problem; the results agree with the problem solution that has been performed by using genetic algorithm method under certainty.

Keywords: decision making risks, multi-agent modeling, numerical methods of decisions optimization, scheduling problem, evolutionary modeling

  In article the information system of the MANAGEMENT information system is represented as the three-level model constructed by a principle of cascade maintenance. Problems of delays of the supply with information, formations arising at the expense of delays and data transmission are considered. The mathematical model of system intended for optimization of maintenance on parameter of delays, on the basis of priorities of processes of formation and an information transfer is developed.

Keywords: Sirotkin A.V. information supply, information service delay